Programming Keyless Entry Problems
#1
I have a 97 SE. I had the remote battery checked this morning and it's fine and according to a post from earlier today I have the right remote. The first time I tried the programming I know I didn't do things in the right order. I tried again today and when I put the key in and out of the ignition, the hazards won't blink. They did the first time I tried it. I thought the code entry enable state and setting mode remain until the driver's door is opened. I assumed when trying again the hazards would blink again. Am I missing something?
Thread
Thread Starter
Forum
Replies
Last Post
Omar Abdurrahman Siddiqi
5th Generation Maxima (2000-2003)
33
08-26-2016 05:18 PM