hi there...can someone help me...i can't seem to remove the factory windshield washer from the hood...can someone tell me how to remove it...thanks

 

unplug the hose for the water, use some needle nose pliers and pull. not to hard. feel around its like a clip thing up there.

 

I removed mine and ended up breaking both of them. So be careful!

 

thanx for the response...i believe i've seen the hose...but how do remove that washer nozzle...is there like a clip there
after i remove the water hose...i don't wanna break it while trying to remove it...thanx for the advice...i'm pretty sure i would break it too...can ya'll help
clarifying what i need to do...thanx again

 

it's like a clip...u have to push in both sides from under the hood...just get a screwdriver...and do front and then it should pop out easy

 

Push it as far as you can towards the rear of the car... that should help...

 

I messed up one of mine before I was told how to remove them as well, I spent like 20 minutes on one of them... Once I learned how it took me 3 minutes to remove both of them....All you have to do is push the two clips on each side (you can feel them with your fingers) towards the center of the hose connecter. It was easier for me to push one in and then at the same time push the washer out on one side and then do the other side and it will pop out quick.

Also, when putting in the new ones... be careful... I dropped one of the black spacers into the hood and lost it forever It was the large one too....

Alec