Couple question on the MEVI install
Couple question on the MEVI install
This manifold was bought from someone on the forums.. and it comes with a summit racing black box.
Well i was woundering where i get power from when i connect RPM switch.

Where do i connect this? It says, Normally open something something, i have to look at that..
another question, could i just run with the butterflies open?
Well i was woundering where i get power from when i connect RPM switch.

Where do i connect this? It says, Normally open something something, i have to look at that..
another question, could i just run with the butterflies open?
Maybe this will give you some clues to your questions:
http://www.vqpower.com/v2/infusions/...?article_id=50
http://www.vqpower.com/v2/infusions/...?article_id=50
One last question, how do i get it to turn on from 5500 -7400? IS this a rpm setting to turn it on?

http://store.summitracing.com/partdetail.asp?part=SUM-830449
Sounds like you haven't read the instructions. Check them out here. Should answer all your questions.
http://store.summitracing.com/partdetail.asp?part=SUM-830449

http://store.summitracing.com/partdetail.asp?part=SUM-830449
Nah i havent read the instruction, i bought it used so it didnt come with any. Thanks for the link
To set the activation point you have to adjust the DIP switches and you can fine tune with the little dial.
Assuming you have a decent multimeter, you can check your TPS.
See link.
http://www.vqpower.com/v2/infusions/articles/readarticle.php?article_id=95
See link.
http://www.vqpower.com/v2/infusions/articles/readarticle.php?article_id=95
Thread
Thread Starter
Forum
Replies
Last Post
Lakersallday24
6th Generation Maxima (2004-2008)
14
Nov 7, 2024 07:31 PM
MAXSE5SPD
Other For Sale/Wanted
2
Aug 23, 2015 12:06 PM
MaximaDrvr
7th Generation Maxima (2009-2015)
16
Aug 19, 2015 08:20 PM






