quick caliper install question
#1
quick caliper install question
so the two caliper slide pins (front) - one of them is solid steel, the other has a rubber end. they are same length. which goes where?
also, when installed the caliper should have enough room to slide 1/8" or so on the slides, right??? why are the friggin autozone calipers too big? there's not enough room for them to slide in the caliper bracket - this will cause the brake to hang/stick, right??
also, when installed the caliper should have enough room to slide 1/8" or so on the slides, right??? why are the friggin autozone calipers too big? there's not enough room for them to slide in the caliper bracket - this will cause the brake to hang/stick, right??
#2
so the two caliper slide pins (front) - one of them is solid steel, the other has a rubber end. they are same length. which goes where?
also, when installed the caliper should have enough room to slide 1/8" or so on the slides, right??? why are the friggin autozone calipers too big? there's not enough room for them to slide in the caliper bracket - this will cause the brake to hang/stick, right??
also, when installed the caliper should have enough room to slide 1/8" or so on the slides, right??? why are the friggin autozone calipers too big? there's not enough room for them to slide in the caliper bracket - this will cause the brake to hang/stick, right??
Thread
Thread Starter
Forum
Replies
Last Post
Cant_Get_Ryte
5th Generation Classifieds (2000-2003)
3
08-28-2015 06:41 AM
RealityCheck
4th Generation Maxima (1995-1999)
2
08-05-2015 06:18 AM