b-pipe hanger broke
#1
b-pipe hanger broke
dang it, im sad. I was driving home and went over a bump and heard a little thump from under the car so i pulled over and was like what the heck is that noise!? Looked under the car and saw the resonator hanging a little bit lower than normal and i said to myself, "that isn't right, that is way too low." I got in the car and drove home then pulled my floorjack out and lifted the car, saw that the rear hanger,( right before it curves to the axle back ) broke!!. Exhaust sags and im going to have to have a shop weld it for me but im thinking of doing an experiment and going to home depot lol. AHH STUPID CALIFORNIA POTHOLES!!!
#4
Experiment as in just waiting to get my custom 2.75" done and putting in my electronic cut out. It hangs but its not hanging till the point where it'll start scarping and sparking. I still make it over speed bumps
#7
#9
Some pics please, if it's not too bad J&B weld is a good temporary fix, I've seen it work for many different parts on automobiles for long spans of time. It won't look the prettiest but until you get the new exhaust you were talking about, it's only 5 bucks so you can't lose.
Thread
Thread Starter
Forum
Replies
Last Post
My Coffee
New Member Introductions
15
06-06-2017 02:01 PM
220k+ A32
5th Generation Maxima (2000-2003)
8
09-23-2015 03:38 PM