Whats this hose?
#1
Whats this hose?
Anyone know what this hose is for? It dies not seal on its connection due to being burnt. Can this cause any problems? It goes under the intake manifold passenger side. Can not figure out how to load pictures so I hope link works
http://s1095.photobucket.com/albums/...Picture026.jpg
http://s1095.photobucket.com/albums/...Picture026.jpg
http://s1095.photobucket.com/albums/...Picture027.jpg
http://s1095.photobucket.com/albums/...Picture026.jpg
http://s1095.photobucket.com/albums/...Picture026.jpg
http://s1095.photobucket.com/albums/...Picture027.jpg
#2
That is part of the crankcase ventilation system. It connects the 2 valve cover chambers so that the one PCV valve can do both sides of the engine. I had to replace my hose when I did valve cover gaskets because my hose was so brittle that it cracked when I took it off.
#3
That is part of the crankcase ventilation system. It connects the 2 valve cover chambers so that the one PCV valve can do both sides of the engine. I had to replace my hose when I did valve cover gaskets because my hose was so brittle that it cracked when I took it off.
I advise you get a new hose ASAP
#5
If I'm not mistaken, it's a vacuum hose that bridges from the front valve cover to the rear valve cover.
If it's cracked or if it's not holding a seal I'd get a hose and replace it. I replaced mine with a generic aftermarket hose.
If it's cracked or if it's not holding a seal I'd get a hose and replace it. I replaced mine with a generic aftermarket hose.
#10
Thread
Thread Starter
Forum
Replies
Last Post
HerpDerp1919
3rd Generation Maxima (1989-1994)
2
09-29-2015 02:02 PM