ECU reading codes question
#1
Supporting Maxima.org Member
Thread Starter
iTrader: (2)
Join Date: Feb 2001
Location: palatine, il
Posts: 347
ECU reading codes question
I am using either Nistune or ECUtalk to read codes from my Maxima so I can get it to finally pass wonderful emissions testing.
I had a 0400 and rear o2 sensor which I fixed both and cleared codes. I am now noticing that whenever I check for codes that it says 055 but for number of starts it is always 0. I know on my 300zx this will always increase with each car startup.
I am using a JWT ecu and I have seen this number be different values when I had an error code.
I just tried to pass emissions the second time and was rejected because my O2 system, Evap and EGR system weren't ready. Is there a piece of software out there where I can read this? And is there some setting of turning the screw that would cause the number of starts to always be 0?
Sorry rather odd post just want to get this thing passed so I can get my sticker.
I had a 0400 and rear o2 sensor which I fixed both and cleared codes. I am now noticing that whenever I check for codes that it says 055 but for number of starts it is always 0. I know on my 300zx this will always increase with each car startup.
I am using a JWT ecu and I have seen this number be different values when I had an error code.
I just tried to pass emissions the second time and was rejected because my O2 system, Evap and EGR system weren't ready. Is there a piece of software out there where I can read this? And is there some setting of turning the screw that would cause the number of starts to always be 0?
Sorry rather odd post just want to get this thing passed so I can get my sticker.
Thread
Thread Starter
Forum
Replies
Last Post
1992maximase30
4th Generation Maxima (1995-1999)
3
08-05-2015 09:27 PM
yat70458
5th Generation Maxima (2000-2003)
2
08-03-2015 01:16 PM