Confusion on Corner light LED conversion
#1
Confusion on Corner light LED conversion
So I've got two sets of HIDs in my jdm one piece aftermarket housing, and they look good, but the corner light is a normal halogen bulb but i would like to put an LED light in there. My question is, can a LED light thats the right size bulb fit right into the stock harness for the corner bulb? Or do i need something else to make that conversion? Because from the looks of the ones i wanna purchase they don't look like they would fit right in.
#2
Should be an 1156 or an 1157 depending on year. They are plug and play
1156
http://www.ebay.com/itm/2pc-S25-1156...ead85d&vxp=mtr
1157
http://www.ebay.com/itm/New-NICEST-1...item19d183bdac
1156
http://www.ebay.com/itm/2pc-S25-1156...ead85d&vxp=mtr
1157
http://www.ebay.com/itm/New-NICEST-1...item19d183bdac
#12
also i find with these stlye leds, when youre twisting to try and get the nips into the respected places, its right then and there that the connection for the led usually gets ripped. cuz the bottom will spin seperate from the bulb surrounding the led. you get a half a twist, and you couldve already ruined your new 2 dollar ebay bulb
#14
never had a problem with them. Ive had EBAY led's for over a year throughout the majority of my car
#16
im not saying they come broke from ebay. im saying theyre cheap(just like the rest of them) and if youre not careful while twisting it in to its socket you could break a connection inside.
#17
also ive gotten some from ebay that wouldnt light up unless i pressed the light down a little harder onto the connection. the way it sat normally wouldnt illuminate it. or if it would iluminate, a minute down the road itd wiggle and go out.
Thread
Thread Starter
Forum
Replies
Last Post
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM
Dennis Twohy
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
0
10-01-2015 06:01 PM
jds22
8th Generation Maxima (2016-)
5
09-04-2015 01:52 PM