Clutch pedal still sinking halfways
#1
Clutch pedal still sinking halfways
Wat up guys,
I just finished installing my SS clutch line in my 99 maxima 5spd with 218617 miles. Bleed the line no air. My car shifts smoothly with no problems but when I slightly press on the clutch pedal it sinks halfway to the floor then will fully press pedal down but clutch does not engage until I pull it back up with my foot and Press down again to engage clutch. I have replaced the master and slave cylinder before my SS line do to the same problem thinking the SS line would resolve it. Tranny and clutch were replaced no more than 2 years ago nothing special done to them. I have a few thoughts what else may be the problem but at this point I would rather speak to more experienced peeps. No other problems with my car just want to resolve this one. Thanks guys!
I just finished installing my SS clutch line in my 99 maxima 5spd with 218617 miles. Bleed the line no air. My car shifts smoothly with no problems but when I slightly press on the clutch pedal it sinks halfway to the floor then will fully press pedal down but clutch does not engage until I pull it back up with my foot and Press down again to engage clutch. I have replaced the master and slave cylinder before my SS line do to the same problem thinking the SS line would resolve it. Tranny and clutch were replaced no more than 2 years ago nothing special done to them. I have a few thoughts what else may be the problem but at this point I would rather speak to more experienced peeps. No other problems with my car just want to resolve this one. Thanks guys!
Thread
Thread Starter
Forum
Replies
Last Post
My Coffee
New Member Introductions
15
06-06-2017 02:01 PM
HerpDerp1919
3rd Generation Maxima (1989-1994)
2
09-29-2015 02:02 PM