It's clear .....
#7
Broke plenty !
First time, tried it with a har dryer....didn't work worth sh*t!
Chipped the edges of the lens, good ole Crazy Glue to the rescue.
Got a heat gun, and that was the trick, that and patience.
Then on the first lens, I cut the clears to match the amber that I pulled out, put it together and notice it looked like crap. Had to take it apart again, and becuase I lost my patience, peeling the lens and back apart, I cracked the edge of the lens that goes in the groove. Again, Crazy Glue to the rescue.
I put in amber bulbs, not looking to attract too much attention, and don't have any hook ups when it comes to state inspections.
I think I might disconnect that small bulb in the corner that goes to that red lens (does everyone else do that?)
I will wash the car this weekend, and hopefully post some pics early next week.
First time, tried it with a har dryer....didn't work worth sh*t!
Chipped the edges of the lens, good ole Crazy Glue to the rescue.
Got a heat gun, and that was the trick, that and patience.
Then on the first lens, I cut the clears to match the amber that I pulled out, put it together and notice it looked like crap. Had to take it apart again, and becuase I lost my patience, peeling the lens and back apart, I cracked the edge of the lens that goes in the groove. Again, Crazy Glue to the rescue.
I put in amber bulbs, not looking to attract too much attention, and don't have any hook ups when it comes to state inspections.
I think I might disconnect that small bulb in the corner that goes to that red lens (does everyone else do that?)
I will wash the car this weekend, and hopefully post some pics early next week.
Originally posted by Str8ridin
Cool! Breakanything? How long did it take you? Oven or heatgun?
Cool! Breakanything? How long did it take you? Oven or heatgun?
Thread
Thread Starter
Forum
Replies
Last Post
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM
My Coffee
New Member Introductions
15
06-06-2017 02:01 PM
doctorpullit
8th Generation Maxima (2016-)
13
04-23-2017 05:35 AM
Kyle Lee Cleveland
6th Generation Maxima (2004-2008)
1
09-28-2015 09:01 PM