I have this P1105 code that keeps setting off my check engine light. I have a subscription on All Data and this code doesn't even appear for this car. I have check all hoses and connections and I can't seem to track down the issue. My vehicle is a 1997 Nissan Maxima GLE, manual transmission. Was able to fix all the other codes already. If I reset the codes, the car runs fine. The light will stay off until I shut off the car and then when I turn it back on, a few secs later the check engine light comes back on. Anyone else have this issue and if so, how did you fix it?

Thanks for the help.

 

Possible Faulty Map/Baro Switch

1) Check to see if the fuse is good (fuse number 17 10 amp fuse)

2) Map/Baro Switch Valve - may need replacement.

Here's a thread on this subject below.

http://forums.maxima.org/4th-generat...-solenoid.html

 

I'm much less than impressed with All Data.

See page 277 is section EC of the Nissan service manual:
http://boredmder.com/FSMs/Nissan/Maxima/1997/EC.pdf

 

Maxima GLEs were automatic only. You either have a GXE or an SE. The SE had white faced gages (speedo, rpms, etc), rear spoiler, and foglights standard. A GXE could have some of that but most likely not the white faced gages. Which one is yours?

 

OP, could have did a 5 speed swap....

 

Doubt it, cause if he did, figuring out this engine code CEL would have been child's play.

 

Thank you Dennis.. you picture sure helped. I enjoy the big right lable and the color coding.. That was a life saver since two solinoids are amost labeled alike, look alike, and appear to perform the same thing. Thank you.