Alternator sub harness retaining pins
#1
Any word on where these two plastic pins (molded into the alternator sub harness end) attach to the car? Right now the excess slack on the harness is just kind of folded into position - I don't see anywhere within reach to mount the harness/these two plastic pins. What's a good link to those ASSEMBLY DIAGRAMS (not just the FSM drawings) that I see posted sometimes ? Thanks
[QUOTE="reallywildstuff;9115842"]The 96-97 alternator fits and the car is back on the road. I installed a new alternator harness - it has two retaining clips on the engine harness side. Where are they supposed to clip into?/QUOTE]
[QUOTE="reallywildstuff;9115842"]The 96-97 alternator fits and the car is back on the road. I installed a new alternator harness - it has two retaining clips on the engine harness side. Where are they supposed to clip into?/QUOTE]
Last edited by reallywildstuff; 07-04-2016 at 08:30 PM.
#5
Ive created a Flickr album. Is this the best way to post photos to the forum? I tried using the maxima.org app's "add photo" feature and got an ugly error message that then crashed the app...
https://flickr.com/photos/78849780@N...57671454352911
The two grey plastic pins I'm referencing are prominently featured at the end of the alternator sub-harness.
"Where did they come from Where did they go?"
The alternator sub-harness isn't long enough for the pins to snap into holes anywhere near the AC compressor.
https://flickr.com/photos/78849780@N...57671454352911
The two grey plastic pins I'm referencing are prominently featured at the end of the alternator sub-harness.
"Where did they come from Where did they go?"
The alternator sub-harness isn't long enough for the pins to snap into holes anywhere near the AC compressor.
Thread
Thread Starter
Forum
Replies
Last Post
BlackoutSE
5th Generation Maxima (2000-2003)
0
03-31-2016 07:00 AM