Direction of stock cat install?
Thread Starter
Senior Member
Joined: Apr 2001
Posts: 517
From: eastern, MA
Direction of stock cat install?
I remove the cat as part of an exhaust install.
I marked the direction... but the marks were not very clear by the time I got it torched out and the studs drilled out. So, I'm not 100% sure I got it installed in the right direction.
The only difference I see in looking at it is that at one end, on one side, there are two big knubs. Other than that, both ends look the same.
Any idea which end and top or bottom the knubs go at? OR is there some other way to tell how to position it?
I marked the direction... but the marks were not very clear by the time I got it torched out and the studs drilled out. So, I'm not 100% sure I got it installed in the right direction.
The only difference I see in looking at it is that at one end, on one side, there are two big knubs. Other than that, both ends look the same.
Any idea which end and top or bottom the knubs go at? OR is there some other way to tell how to position it?
Thread
Thread Starter
Forum
Replies
Last Post
blackY2Kmax
5th Generation Maxima (2000-2003)
6
Sep 15, 2000 05:55 AM