Wheel Bearings (Front)
#3
All if not most wheel bearing have seals built with the bearing. The wheel bearing you want is nissan they are good. The moog wheel bearing is also good. The timko is another good brand you wanna go with.
#4
https://www.ebay.com/itm/NSK-FRONT-W...R/132105190531
NSK (link above) are who Nissan uses for bearings. They are OEM.
Yes you need separate seals, both sides, per wheel, and while you're at it, new retainer clips. Just like in the kit above.
Bearings for our Maximas DON'T come with built in seals, so don't make yourself crazy looking for them.
NSK (link above) are who Nissan uses for bearings. They are OEM.
Yes you need separate seals, both sides, per wheel, and while you're at it, new retainer clips. Just like in the kit above.
Bearings for our Maximas DON'T come with built in seals, so don't make yourself crazy looking for them.
Last edited by KP11520; 04-21-2018 at 12:20 PM.
#6
The wheel bearing and the seals come together when you buy a whole wheel hub bearing assembly. I tryed Nissan and they use to sell the whole assembly. Nissan now are cutting back on all of our parts.
#7
The only assemblies are for the back. The front bearings get pressed into the steering knuckles (No place for any assembly in there) and the retainer clips keep them in position centered in the knuckle. Then the seals are pressed into both outer edges of the steering knuckle. The hub assembly gets pressed in after the steering knuckle is completed. The Hub and Wheel Studs make up the hub assembly.
If you bought a complete Nissan "Assembly".... That would be a new steering knuckle, backing plate, bearings, retainer clips, seals, hub assemblies, steering stop bolt and plastic cap, ABS sensor and applicable bolt. Approaching well over $1K each side.
Research before you post. Shooting from the hip hurts others when it misses.
Maybe you mean kit and if you click on the kit link I posted above, it might make some sense.
#8
I looked at your link and when I mean, I bought the whole assembly it was new with everything. The thing was freaking expensive because it was new with everything ready to go. I am only talking about the front assembly's. If you go and buy from napa they got all the assembly ready to go. The whole assembly with the knuckle steering included that can be found on off a junk yard car. The whole hub assembly with bearing and knuckle with seals are sold at the stores like advance and Nissan ready to go.
#11
#15
#16
Yep thanks. I just bought a new NSK Left Right replacements LESS the snap rings lol, good to know.
Thread
Thread Starter
Forum
Replies
Last Post
03VQMAX
5th Generation Classifieds (2000-2003)
5
11-02-2013 06:32 PM
Extremerecluse
4th Generation Maxima (1995-1999)
4
01-17-2013 12:55 PM
Deckdout2
All Motor
31
12-24-2009 06:00 AM
racin89lx
4th Generation Maxima (1995-1999)
1
07-24-2006 08:34 AM