I'm in the process of clearing out my tails right now and I have the orange out now and have started cutting but I already know its going to be a pain in the @ss so before I crack to much of the light cover then I figure I would ask what is best to use for cutting it perfect.



Max99

 

USE a dremel to cut it, very fast and smooth cut

 

dremel or a soldering iron with a ruler or something

 

I don't have a dremel so I used a jigsaw and heated up the plastic with a heat gun occasionally to keep it somewhat soft so it wouldn't crack. Works pretty good. Depends on what tools you have available I guess. Good Luck

 

Just use the utility knife with a ruler and then use sand paper.

 

I use a dremel with the fiberglass reinforced cutting disc

 

i used a dremel and i tried cutting it but it was choppy and rigged. Maybe i used the wrong tool should i go and fix it cause the sheet i used wasn't as clear as the reverse light.

Chris

 

I used a fork and spoon.

I think we used a dremel and about 4-5 discs. he he he Relief cuts are worth your time!!!