i noticed that there was a bracket on each rear suspension arm holding what looks like the ebrake cable. if i remember correctly its a 10mm bolt. should i loosen or remove this bolt and let the cable loose? right now i didn't touch the ebrake cable and it sits tightly around the U bolt of the rear sway bar. doesn't seem like it interferes, but i was just wondering in case i wanted to adjust the bar setting slightly..

 

I think I know what your talkin about. I left the cable alone. I did loosen the 10mm bolt in order to get the brackets behind it, however, when finished I tightened it back. I say leave it as is cause you don't want to loosen it or leave it hanging because it might catch on to something. IMO

 

Hmm..I remember reading about having to loosen the e-brake cable, but when I installed my Addco RSB the e-brake cable wasn't in the way at all so I didn't even touch it.

 

When I installed mine I used pictures from the web, like MegaMaxe's website and someone else's I beleive. All of them had the u-bolt on top of and around the e-brake cable, and I copied that install. It makes sense since th e-brake cable only has a steel wire in it, so tightening things around it won't hurt its functionality too much, unlike if it was a hydraulic line . . . . .

DW