Reprogramming the Computer for Different Remote Functions
#1
Reprogramming the Computer for Different Remote Functions
There's a project that interests me, but I'm not sure where to start. I'd like to change the programming in the computer that handles what to do with signals from the remote control. Currently, the buttons do the following:
+ lock all doors
+ unlock all doors -- if held, roll down the front windows
+ open the trunk
+ set off the alarm
I'd like mine to do the following:
+ lock all doors -- if held, roll up all windows and close the sunroof
+ unlock all doors -- if held, roll down the front windows
+ open the trunk
+ lower all windows one inch and tilt open the sunroof
I'm sure this is possible in theory, though I may not have the tools necessary. I do have access to an eprom burner.
Has anyone done anything like this or heard of anyone else who has? I'd appreciate any tips anyone has, even pointing me in the direction of more information.
+ lock all doors
+ unlock all doors -- if held, roll down the front windows
+ open the trunk
+ set off the alarm
I'd like mine to do the following:
+ lock all doors -- if held, roll up all windows and close the sunroof
+ unlock all doors -- if held, roll down the front windows
+ open the trunk
+ lower all windows one inch and tilt open the sunroof
I'm sure this is possible in theory, though I may not have the tools necessary. I do have access to an eprom burner.
Has anyone done anything like this or heard of anyone else who has? I'd appreciate any tips anyone has, even pointing me in the direction of more information.
#2
i know inside wiring (windows/locks) uses multiplexor, so you will need to decode the signal. for sunroof, it needs hard wiring to the sunroof switch, as it is not part of the MUX. i think.
check your wiring diagrams in your hanes manual.
check your wiring diagrams in your hanes manual.
Thread
Thread Starter
Forum
Replies
Last Post
Omar Abdurrahman Siddiqi
5th Generation Maxima (2000-2003)
33
08-26-2016 05:18 PM