350z upper and lower intake manifold
#1
Supporting Maxima.org Member
Thread Starter
iTrader: (10)
Join Date: Oct 2006
Location: Hershey, PA
Posts: 371
350z upper and lower intake manifold
I have an upper intake manifold (2 pieces) and also the 350z lower intake manifold that i was going to experiment with but my plans have changed and will not be needing this anymore. it is everything to bolt these manifolds on to the car, all the bolts/nuts and gaskets, pics coming tonight.
I am looking for $250 shipped
edit: price drop
I am looking for $250 shipped
edit: price drop
Last edited by coinage; 09-14-2007 at 09:05 AM.
#4
Supporting Maxima.org Member
Thread Starter
iTrader: (10)
Join Date: Oct 2006
Location: Hershey, PA
Posts: 371
the upper part of the plenum needs modified to fit, but other than moving some wires it drops right in. there is a post in the advanced all motor section abuot the manifold and explains whts needs done.
so in short, you will need to cut the "elbow" and weld a staright tube to allow the hood to close and you will need to make an intake
so in short, you will need to cut the "elbow" and weld a staright tube to allow the hood to close and you will need to make an intake
#9
Supporting Maxima.org Member
Thread Starter
iTrader: (10)
Join Date: Oct 2006
Location: Hershey, PA
Posts: 371
i dont think it can cost that much to have it cut and a tube welded on... maybe the only pricey thing would be the TB flange?
PS: please buy my stuff! my other car needs some lovin
^ not for sale lol
PS: please buy my stuff! my other car needs some lovin
^ not for sale lol
Thread
Thread Starter
Forum
Replies
Last Post
pears
5th Generation Maxima (2000-2003)
15
09-18-2015 05:25 AM