PA Berk Intake
#1
Berk Intake
I have a used Berk Intake for sale. Had it on my car for about 500 miles before it was removed. I bought it from another Org member who previously had it installed on his car as well.
The rubber piece at the end and the MAF sensor/housing are not included. The MAF adapter plate was just barely the wrong size but modified to fit to the MAF housing. It goes on just fine with nuts added to each screw. I think I have four that I can include if you'd like.
Bring your own MAF sensor/housing and rubber piece and you can have a nice, clean intake setup exactly as picture minus the blue coupler (will be better without it, I didn't realize until I took it off that it was not necessary).
$135 shipped - Midpipe, blue coupler, clamps, MAF adapter plate, black coupler in the picture, dirty filter/no filter if you don't want it
$155 shipped - everything as listed above and a brand new filter that wasn't even used for 50 miles as seen in picture
Any questions let me know. Thanks.
The rubber piece at the end and the MAF sensor/housing are not included. The MAF adapter plate was just barely the wrong size but modified to fit to the MAF housing. It goes on just fine with nuts added to each screw. I think I have four that I can include if you'd like.
Bring your own MAF sensor/housing and rubber piece and you can have a nice, clean intake setup exactly as picture minus the blue coupler (will be better without it, I didn't realize until I took it off that it was not necessary).
$135 shipped - Midpipe, blue coupler, clamps, MAF adapter plate, black coupler in the picture, dirty filter/no filter if you don't want it
$155 shipped - everything as listed above and a brand new filter that wasn't even used for 50 miles as seen in picture
Any questions let me know. Thanks.
Last edited by Waxima; 05-10-2011 at 07:05 PM.
#3
Thanks. I hope you're right because I just dropped close to 500 dollars on repairs to my car so I could use the money right now.
Also please pardon the ghetto coat wire hanger being used to secure it in place in the picture, that was temporary.
Also please pardon the ghetto coat wire hanger being used to secure it in place in the picture, that was temporary.
#8
Bump kind of surprised this isn't gone yet. Also the blue coupler is really no good anymore so I'm only going to include it if the buyer insists to cut down on the packaging needed a little bit. The filter sticks on to the MAF adapter plate just fine without the blue coupler.
Add your own MAF sensor/housing and accordian piece and you've got a real nice intake setup.
Add your own MAF sensor/housing and accordian piece and you've got a real nice intake setup.
Thread
Thread Starter
Forum
Replies
Last Post
maxima297
4th Generation Maxima (1995-1999)
4
09-30-2015 03:32 PM