All the links that I came across in the search were dead (including the FAQ section).

I'm looking to take on that rattle this weekend!

Thanks!

 

Hello?

 

i'm kinda curious about this myself. i've got a roll of dynamat to install and haven't gotten around to doing it yet. i was just going to wing it, but advice is always helpful.

 

Sure do, scale of 1-10 10 being the hardest, I rate this a 7. You have to take out the seats first, the plastics around the seats, the trim on both sides od the rear window. If you need diagrams, let me know. I think I might be able to e-mail them to you. I removed mine and put down some carpet like material and now not 1 Single rattle from the deck.

 

I sent you a PM with my e-mail. Thanks.

 

Could you guys share the info.

I once went as far as removing the rear seat and removing the black plastic screws in the black walling behind the seat but then got stuck on the next move.

thanx
woosh

 

I just cheated. I used peel-n-seal (poor mans dynamat) in the trunk, and sprayed insulation foam in the back declid between the metal and the decklid. Quiet!

 

I have some pics from my srping install that show the rear seat and pass through removal quite thoughly...

http://www.nissanx.net/gall/album46

 

I just installed Dynamat Xtreme on my rear deck a couple days ago. Removed everything the same way as listed above. The metal part of it stays on there, so I just dynamat'ed carefully around there. It got rid of pretty much all the rattles. There are still some things you can't fix, like the childseat anchors, trunk lid springs, etc...

 

Thanks Maxxximus! I'll bring my wireless laptop out to the garage and try the removal tomorrow!

 

Check your E-mails!!!!!!!!!!!