FrankenCar Intake support bracket?
#1
FrankenCar Intake support bracket?
I'm having a little trouble with it. It only seems to fit correctly on the side of the MAF and not the side of the Steel MAF bracket. When I put it on the side of the Steel MAF bracket, it pulls the intake too close to the strut tower and the filter hits the metal piece on the strut tower that's holding some wiring. With it attached to the MAF side, the nut comes loose after some time. Any suggestions?
Why is there so much space between the Apexi filter adapter and the MAF adapter? It appears there is about a half to an inch gap.
Why is there so much space between the Apexi filter adapter and the MAF adapter? It appears there is about a half to an inch gap.
#5
It's actually not easily adjustable. When it's on the MAF adapter side, it pulls the Apexi filter into a OEM metal piece on the strut tower. The metal piece has electrical wiring. It's almost as if the piece should be longer. I'd rather have the brace that's pictured on his site. It looks like a better hanging brace all together.
Thread
Thread Starter
Forum
Replies
Last Post
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM
Calabar
4th Generation Classifieds (1995-1999)
3
10-05-2015 09:57 PM
maxima297
4th Generation Maxima (1995-1999)
4
09-30-2015 03:32 PM