Going to install the Berk this weekend. Would be helpful to me if I could see some picks of how it looks in the 00-01 Max before I begin.

Thanks!

Why do you have the MAF pointing down?

Because I'm an idiot I was in a hurry when I installed it and that's just how it turned out. Once it gets warmer out I'm gonna turn it around, makes no difference either way, wire's long enough to reach it just fine.

do u live in alaska?? i changed the brakes, pvc valve, antifreeze, oil, washed her, changed plugs 3 times, and i live in indy..freakin cold here!! down some tequila and get to work j/k

LoL, did my intake, brakes, pcv valve and two oil changes this winter, but that was all on the days it was unseasonably warm Now that it's staying light out later I've got a basement full of mods and general maintenance items that need attention.

Oh. One other question, does the intake move around alot when the engine is running, and does the bracket which goes to the intake secure it enough?

(also, how do you like it?)

Yea, the bracket secures it fine - it's not attached in the picture, but it is now, I have it tightened down on the intake, but not totally tightened on the strut tower to allow for a little movement - no it doesn't move around a lot at idle...wouldn't know about at WOT because I'm usually behind the wheel and not in the engine bay...

I love the intake, it roars above 3,500 RPM, you'll enjoy it!

I really need to clean my engine bay

check website

Ok, got mine in last night. Here are two picks:

http://www.scuderi.net/car/

My impresion is positive for the most part. I notice quicker throttle response, very nice growl on acceleration, no loss of low end power that I can tell, quiet on idle and crusing, and the whistle on moderate acceleration. Only the whistle I'm not too sure about.

Overall, the car feels like it has more "life".

Thanks to those that posted a pic, it helped with my install.

i just bought a berk mid pipe to replace my frankencar but my frankencar had a hole in it next to the big tube for something and my berk doesnt...what do I do?

Not sure what you mean.

My Berk mid-pipe has a long tube coming off the side with three spots to connect the rubber tubes to. Everything fit fine.

my frankencar had a hole in it next to the main tube...i'll try to find a pic of a frankencar pipe or someones set up

Pic would be good, but what did you use the hole for? Was it just open to the air?

the hole is for the air temperature sensor I think. its the thign that is stuck in the scoop.

That is correct. It should stay there.

I put mine in my frankencar, i took the scoop off my car... doesnt really make a difference...