p0430?...what?
Catalyst System Efficiency Below Threshold (Bank 2)
Base on the manual:
The ECM monitors the switching frequency ratio of front and rear heated oxygen sensors. A warm-up three way catalyst with high oxygen storage capacity will indicate a low switching frequency of rear heated oxygen sensor. As oxygen storage capacity decreases, the rear heated oxygen sensor switching frequency will increase. When the frequency ratio of front and rear heated oxygen sensors approaches a specified limit value, the warm-up three way catalyst malfunction is diagnosed. Malfunction is detected when warm-up three way catalyst does not operate properly, warm-up three way catalyst does not have enough oxygen storage capacity.
It is like P0420 (bank 1).
Base on the manual:
The ECM monitors the switching frequency ratio of front and rear heated oxygen sensors. A warm-up three way catalyst with high oxygen storage capacity will indicate a low switching frequency of rear heated oxygen sensor. As oxygen storage capacity decreases, the rear heated oxygen sensor switching frequency will increase. When the frequency ratio of front and rear heated oxygen sensors approaches a specified limit value, the warm-up three way catalyst malfunction is diagnosed. Malfunction is detected when warm-up three way catalyst does not operate properly, warm-up three way catalyst does not have enough oxygen storage capacity.
It is like P0420 (bank 1).
You may check this
http://maxima.theowensfamily.com/tsb/NTB00-070a.pdf
http://maxima.theowensfamily.com/tsb/NTB00-070a.pdf
Originally Posted by gameover03
Im In Ny So I Fed Spec,....
autozone told me this...
" the pcm has determined that the catalyst system efficiency for bank 2 is beow threshold for the current engine operation conditions. (bank 1 identifies the location of cylinder #1, while bank 2 identifies the cylinders on the opposite bank.)"
I have a fed spec...can n e on help me out...
" the pcm has determined that the catalyst system efficiency for bank 2 is beow threshold for the current engine operation conditions. (bank 1 identifies the location of cylinder #1, while bank 2 identifies the cylinders on the opposite bank.)"
I have a fed spec...can n e on help me out...
Thread
Thread Starter
Forum
Replies
Last Post
FLO_BOY
4th Generation Maxima (1995-1999)
36
Aug 20, 2003 10:20 PM
pmas76
5th Generation Maxima (2000-2003)
8
May 27, 2003 10:10 AM




