ornery1

iTrader: (1)

my 1 fog is aimed to low i want to raise the beam pattern, how do you do this?

max929

iTrader: (3)

not excactly sure, but I'm pretty sure u have to take it out and ajust it in it's housing.

ornery1

iTrader: (1)

i dont think thats it,i replace bulbs many times on it already

tophersworld

There is a white adjustment screw at the bottom of the back side. You will have to remove a couple of screws and clips to bend the front of the inner fenderwell enough to reach it from underneath. To reach it from above remove your headlight but it is hard to see. You will have to do it by feel.

You can only adjust up and down with the adjustment screw.

Lontar1

iTrader: (5)

and still you wont see crap with them, unless you get HID's for the fogs...... ours Fogs SUCKs

chr0nos

iTrader: (1)

Where did everybody get their HID fogs, and what brand did you get?

ColdSHO

iTrader: (25)

mine take forever to align, the white screww is the best way tho. just gotta align, check, align, check....

i just redid mine, i have to align all over again

igzy

iTrader: (18)

Recently I installed the yellow capsules and noticed that light was brighter... I think it is mostly due to the fact that the installation requires permanent removal of the light guards which limit the light coming out. So you can may be think about just opening the lens and removing the "guard"...

ColdSHO

iTrader: (25)

i removed my guards, but havent had a chance to test ou the lights yet, cars at the dealership right now, but they looked 3x brighter than they did with the guards in, but then agaqin my bulbs are much longer than a standard h3.

tophersworld

I agree with that. I have too many mods with 2 vehicles and a house to get HID's now but I was playing around and made a Frankenstien Projector / Angel eye fog. It has better light than OEM.





If you are interested in what I did on the cheap the writeup is Here