khynex

iTrader: (1)

i went 1 steps colder on the plugs 2day and now my car idles at 1000-900 any ideas?

Scriz92SE

you can reset the idle..not sure the process, but i'm sure its somewhere around the forum. and if that doesn't work then i'd say go back to the other plugs..besides 900-1000 isn't that bad of an idle..although my car idles at 1500, still haven't figured it out yet

siren001

after my ypipe i idle at about 1100

steven88

iTrader: (28)

Idle Air Volume Learning (Throttle Position Learning)
It is better to count the time accurately with a clock.

Operation Procedures
1. Perform “Accelerator Pedal Released Position Learning”.
2. Perform “Throttle Valve Closed Position Learning”.
3. Start engine and warm it up to normal operating temperature.
4. Turn ignition switch “OFF” and wait at least 10 seconds.
5. Conform that accelerator pedal is fully released, turn ignition switch “ON” and wait 3 seconds.
6. Repeat the following (steps 7a, 7b) procedures quickly five times within 5 seconds.
7a. Fully depress the accelerator pedal (HARD)
7b. Fully release the accelerator pedal.
8. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the Check Engine Light (CEL) stops blinking and turned ON.
9. Fully release the accelerator pedal within 3 seconds after the CEL is ON.
10. Start engine and let it idle.
11. Wait 20 seconds.
12. Rev up the engine two or three times and make sure the idle speed and ignition timing are within the specifications.

siren001

will that work for the 01 too?

alty319

if that doesnt work go see the stealership and have them hook it up to the consult II..

why did u go colder? Usually you do that when you go FI or your heavely modded...

MAXRB8

iTrader: (19)

No this for drive by wire 02-03's


Surpised you haven't thrown a SES light yet. P0507 High RPM code. I ended up having to get the stealership to do a reflash on my ECM.

khynex

iTrader: (1)

steven88...ur the man, my car is now back 2 normal and alot smoother..

MAXRB8

iTrader: (19)

.........