LED Tails...first pic
#41
If it permits, the final design might include a Variable resistor for the setup to give the buyer a simple way to adjust the brightness of the light. Just a thought, looks good though.
#45
ok, installed the led tail prototype today...as you can see I'm still waiting on the signals to be complete but I just wanted to see what what it would look like...again this just a prototype. Let me know what you think. Once I get this complete, I will try to start mass producing if time permits.
#47
LED Tails...first pic
This might have been mentioned before but selling the board w/ LEDS & wiring into factory harness without the whole lens, case & bulbs would be awesome. Maybe a pic or instructions where we shall use our dremels.
Thread
Thread Starter
Forum
Replies
Last Post
bigfrank
4th Generation Maxima (1995-1999)
2
10-01-2015 12:51 PM