I just placed new Xenon HID's on my 2001 Max. They look great except I dont like where they are brightening up the road. They seem to low and I cant seem to see incoming pot holes when driving. Makes it kinda difficult not having those hi-beams. Is there any adjustments to bring these lights up alittle bit higher?

Thanks in advance...

Titot

 

wut HID's did u go with?? and how much did it run??

 

There is a small metal screw on the back, just turn it either way with a socket wrench. That will either lower or raise the assembly.

Dixit

 

Mine are H4's made by Phillip.

 

Interesting. After switching to HID, I have the feeling I should point my headlights further DOWN because of the brightness difference.

Did you have any problems before you switched? Did you have to use high beams often?

As to the question, it was already answered There's a screw on the back of each headlight.

 

Clockwise aims down...
Counter-clockwise aims up...

8mm wrench

 

Aint no need to get TECHNICAL on the forums here..........






Its alright, its only KEV

 

You guys left that out, so the poor guy might be twisting his life away.

 

For all the ppl that got the HID'S to get your haed lamp out do u need to take the bumper off??? Or is there another way?? And how long will it take to get them out??

sorry if i'm reposting something that some one said b4.. but the search this dosen't work that well..

 

If you are getting an aftermarket set of HID's, there is no need to remove the headlamp assembly at all. All you have to do is take out the old bulb and put in a new one.

If you are talking about the 2K2 headlamp assemblies, no you still don't need to take the bumber off.

 

Hum.. i didn't know that.. some one said b4 that u need to take the bumper off to get the headlamps out.. i guess not.. so i can just un screw all screws holding the headlamp in w/o removing the bumper.. sounds good..

 

Thanks guys. I did the adjustment and everything is bright as hell.