P0151,P1151,P1167
Thread Starter
Joined: Dec 2003
Posts: 451
From: FightinPhilsZone
P0151,P1151,P1167
Just installed genIII with an O2 sim properly attached. Now 3k later have these codes (1151,1167,0151)
http://forums.maxima.org/showthread.php?t=559038.
Question is could this be related to a single sensor or do I perhaps require a dyno and tune. I have no problem dropping the 100 on a sensor but if that does not work then I could have put the money towards a safc and a tune.
Any guidance is appreciated.
http://forums.maxima.org/showthread.php?t=559038.
Question is could this be related to a single sensor or do I perhaps require a dyno and tune. I have no problem dropping the 100 on a sensor but if that does not work then I could have put the money towards a safc and a tune.
Any guidance is appreciated.
Thread Starter
Joined: Dec 2003
Posts: 451
From: FightinPhilsZone
The print out from autozone states:
P1151 "H02S2" - sensor indicates lean. (this is simmed)-white
P1167 "H02S2" - maximum voltage not met (this is simmed)-red
P0151 "H02S1" - the pcm has determined the input from sensor 1 in bank 2 is too low for current operating conditions (this is still in use)-blue
P1151 "H02S2" - sensor indicates lean. (this is simmed)-white
P1167 "H02S2" - maximum voltage not met (this is simmed)-red
P0151 "H02S1" - the pcm has determined the input from sensor 1 in bank 2 is too low for current operating conditions (this is still in use)-blue
Thread
Thread Starter
Forum
Replies
Last Post
Y2KevSE
5th Generation Maxima (2000-2003)
6
Mar 15, 2011 11:11 AM