today i got my first code in 11 months of ownership, i took my car to auto zone and they pulled a p0140 (bank 1 sensor 2 high input)

I have a warpspeed y pipe and i am cali spec so the bank 1 pre-cat is gone but the second sensor on bank 1 is right after the second sensor on bank 2 which does have the pre-cat and i am not throwing a code on that one.

So now that it seems i have a dead o2 sensor i was wondering if it was possible to spice the wires from the b2s2 sensor with the wires of the b1s2 sensor since they should be producing the same signal anyway.

I guess if that isnt a possibility i will pick up a sim

 

im running a po420 code=failed emissions FML....hoping its just a sensor and not an actual cat (just shy of 100,000k miles)

 

bump

 

I'm pretty sure you can't. Compare the 2 o2 sensors and check the numbers on the side. If they are the same then yea but they probley are not the same.