Wheel hopping
#1
Wheel hopping
anyone has experienced wheel hopping under hard acceleration on maximas?
my maxima does that sometimes quick off the line, the front wheels jump and make noise like going over pot holes, car shakes too.
I heard it can be bad for the axles and tranny. is it because my struts are slightly old?
this is what it looks like, not that severe, but you got the idea
http://www.youtube.com/watch?v=DHlEWHJ-o2w
http://www.youtube.com/watch?v=sARgbCkjX4U
my maxima does that sometimes quick off the line, the front wheels jump and make noise like going over pot holes, car shakes too.
I heard it can be bad for the axles and tranny. is it because my struts are slightly old?
this is what it looks like, not that severe, but you got the idea
http://www.youtube.com/watch?v=DHlEWHJ-o2w
http://www.youtube.com/watch?v=sARgbCkjX4U
#2
I have the same problem but mine did it before I changed my struts and still did it after I got new ones. I changed my endlinks and that helped just a tad but it still does it. I'm not sure how to fix this problem.
#5
#8
anyone has experienced wheel hopping under hard acceleration on maximas?
my maxima does that sometimes quick off the line, the front wheels jump and make noise like going over pot holes, car shakes too.
I heard it can be bad for the axles and tranny. is it because my struts are slightly old?
this is what it looks like, not that severe, but you got the idea
http://www.youtube.com/watch?v=DHlEWHJ-o2w
http://www.youtube.com/watch?v=sARgbCkjX4U
my maxima does that sometimes quick off the line, the front wheels jump and make noise like going over pot holes, car shakes too.
I heard it can be bad for the axles and tranny. is it because my struts are slightly old?
this is what it looks like, not that severe, but you got the idea
http://www.youtube.com/watch?v=DHlEWHJ-o2w
http://www.youtube.com/watch?v=sARgbCkjX4U
However, it's likely your motor mounts are old and squishy, allowing the engine to lift too much under load.
I had horrible wheel-hop as well. Installed ES Motor-mount Bushings.
No more hop. Much improved performance.
#12
I was investigating a way to eliminate this. Some other forums with a similar setup have guys taking the two front bolts out the of the cross member and putting 2-4 washers to space the crossmember from the frame. This in turn brings the engine forward helping to reduce wheel hop.
Someone may want to try this
Someone may want to try this
#13
I installed the front and rear ES motor mount poly bushings and the subframe bushings, adjusted my struts to (5) front/rear and it grips with no drama now still wish I had LSD in my A/T TE 2003! But once it cools down, I should be ableto perform 60' launches under 2.0 seconds! I was already down to 2.171!
Thread
Thread Starter
Forum
Replies
Last Post
Andy29
5th Generation Maxima (2000-2003)
8
09-29-2015 05:32 AM