so i hooked up all the wires and cut the maf wire and hooked up the green wire going from eblue to ecu and white wire going from eblue to maf adapator. i start the car and it wont let me rev pass the 2200 RPM. as soon as i hook those two wire back to factory way it works just fine. help me out guys. i am a newbie to installing this.

 

It's getting no MAFS signal. Recheck your e-manage manual for correct wiring.

 

Its deff not reading a MAF signal. check the wiring once again. You may have wired it wrong. Doesn't hurt to check it over again. I hade a similar problem with my VAFCII but it was my knock sensor wire that didn't need to be wired. good luck !!!