so i have a 2000 A33 and my motor and switch is bad on the driver side. i applied power and ground to the motor and nothing, i also checked voltage at the connector and get nothing when i move the switch to move the seat back forward or backward.



so my question is, my seat is heated/power and has an airbag, i found a gray leather seat heated, power and airbag on Ebay , but the listing says 02-03, but i have a 00.

would the connectors fit? what about mounting location?

thanks for replies guys ( and maybe girls too ) , i'm still learning this car .




http://cgi.ebay.com/ebaymotors/02-03...item2c52ea4b83

 

nobody knows?

 

It should wire up the same, but the seat design is different. If you just replace 1 seat it wont match the other.

 

thats ok , i just need to know if the wiring harness is the same for a 2000-2003.

better to not match than to not work, and i can't find a seat for a 2000 with leather/heated/power/airbag anywhere

 

Just the take cushions and cover off of the old seat and put them on the new one so your seats match.

 

I think there are four total connectors. 2 out of the four are supposedly p/p (abs and basic power) but the third and fourth which incorporates wiring for the memory needs identification.

 

yeah i thought about that.

theres a forum member selling a seat, though he says it's ratty, i just need the switch to work and the reclining motor to work.


i can reuse my current seat track and motors and just use what i need from the donor seat...he's selling it for $50 , and is in the same state as i so i'll prolly just go that route..

thanx a mil orgers

 

if it helps i put i30 seats in my 03 max , plugged right up !!!