Inner CV axle installation
05-07-2012, 12:09 PM
#1
Inner CV axle installation
2000 Maxima SE Manual 5 spd.
Due to tore up CV boot, I got new drives side CV axle. Everything went OK, but now how do you make sure that the inner CV shaft ( that goes to the manual tranny) seal correctly. I pushed it as much as I can by hand and got to engage the teeth, but not sure if that is deep enough. I didn't realized about the tranny oil , so now I got to get new tranny since it was pouring down on the floor...oh well.
thanks
Due to tore up CV boot, I got new drives side CV axle. Everything went OK, but now how do you make sure that the inner CV shaft ( that goes to the manual tranny) seal correctly. I pushed it as much as I can by hand and got to engage the teeth, but not sure if that is deep enough. I didn't realized about the tranny oil , so now I got to get new tranny since it was pouring down on the floor...oh well.
thanks
Thread
Thread Starter
Forum
Replies
Last Post
boomerbrian
5th Generation Maxima (2000-2003)
6
10-31-2018 10:25 AM