Remote Start and Auto Adjusting Driver Seat issue
Remote Start and Auto Adjusting Driver Seat issue
I just got the Viper 5704 installed in my 03 Maxima and I just noticed that the seat does not adjust automatically when the key is inserted in the ignition. It does however work fine if I start the car normally. Is this how it is supposed to work? or should I go back the the shop that installed the system?
I just got the Viper 5704 installed in my 03 Maxima and I just noticed that the seat does not adjust automatically when the key is inserted in the ignition. It does however work fine if I start the car normally. Is this how it is supposed to work? or should I go back the the shop that installed the system?
Nice! Thank you I will call them and let them know.
I have an aftermarket radio installed and that comes on with the remote start but I also just noticed is that the OEM security LED keeps flashing even after i insert the key and begin to drive.
I have an aftermarket radio installed and that comes on with the remote start but I also just noticed is that the OEM security LED keeps flashing even after i insert the key and begin to drive.
There is a 3 position rocker switch near your left leg that turns this behavior on(set to AUTO). When the door is opened, the seat slides back to allow for easier egress. When you close the door, it slides forward into the remembered position.
There's no ACC 3 circuit as far as I know. Key sense has to be grounded via the remote start module. You can use the negative (-) low voltage outputs for either acc or ign off the remote start box.
Thus the car will think you are inserting the key --> the box on the top left.
Last edited by luvlexus101; Jun 17, 2012 at 08:45 PM.
Its a two position switch.
There's no ACC 3 circuit as far as I know. Key sense has to be grounded via the remote start module. You can use the negative (-) low voltage outputs for either acc or ign off the remote start box.
Thus the car will think you are inserting the key --> the box on the top left.

There's no ACC 3 circuit as far as I know. Key sense has to be grounded via the remote start module. You can use the negative (-) low voltage outputs for either acc or ign off the remote start box.
Thus the car will think you are inserting the key --> the box on the top left.
Thread
Thread Starter
Forum
Replies
Last Post
scutmud
8th Generation Maxima (2016-)
110
Aug 16, 2018 10:56 AM
shaunkey1
5th Generation Maxima (2000-2003)
4
Aug 18, 2015 10:09 PM




