Maxima Forums

5th Generation Maxima (2000-2003) Learn more about the 5th Generation Maxima, including the VQ30DE-K and VQ35DE engines.

Replaced clutch and flywheel now car won't budge. Goes into gear without pressing clu

Thread Tools
 
Search this Thread
 
Old Mar 17, 2020 | 05:42 PM
Share
  #1  
Mr.myster91's Avatar
Mr.myster91
Thread Starter
Newbie - Just Registered
 
Joined: Mar 2020
Posts: 3
Replaced clutch and flywheel now car won't budge. Goes into gear without pressing clu
2003 6spd won't move. Clutch pedal still firm. I am stumped. Throw some suggestions my way please. If it helps, the only gears there's any resistance are 5 and 6. Sounds like something spinning.
Reply
Old Mar 17, 2020 | 07:20 PM
Share
  #2  
freezer's Avatar
freezer
Senior Member
 
Joined: Apr 2017
Posts: 308
From: Lloydminster, CAN
Did you confirm the clutch disc splines engage the input shaft prior to assembly?
Reply
Old Mar 18, 2020 | 05:35 AM
Share
  #3  
Mr.myster91's Avatar
Mr.myster91
Thread Starter
Newbie - Just Registered
 
Joined: Mar 2020
Posts: 3
Originally Posted by freezer
Did you confirm the clutch disc splines engage the input shaft prior to assembly?
When you say this, are you referring to using the liner tool to make sure the clutch is lined up? I was under the impression that if that's the case then the tranny would automatically be in the correct spot.
Reply
Old Mar 18, 2020 | 05:45 AM
Share
  #4  
freezer's Avatar
freezer
Senior Member
 
Joined: Apr 2017
Posts: 308
From: Lloydminster, CAN
I mean, did you at any point take the clutch disc and put it on the input shaft? Maybe you got the wrong disc (shaft size too big)
Reply
Old Mar 18, 2020 | 07:01 AM
Share
  #5  
Mr.myster91's Avatar
Mr.myster91
Thread Starter
Newbie - Just Registered
 
Joined: Mar 2020
Posts: 3
Originally Posted by freezer
I mean, did you at any point take the clutch disc and put it on the input shaft? Maybe you got the wrong disc (shaft size too big)
no I didn't put it on the input shaft but the alignment tool was ordered for that particular model so wouldn't it be the same size? 😕
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Smoked clutch now shimmying on take off?
K20z1_rsx
5th Generation Maxima (2000-2003)
7
Nov 13, 2008 06:43 PM
clutch flywheel and cv's question.
skweaky
4th Generation Maxima (1995-1999)
3
May 30, 2007 09:54 AM
New clutch @ 43k!!!!!
makavelisk
5th Generation Maxima (2000-2003)
6
Jul 7, 2005 04:13 PM
New clutch and flywheel installed...
mtrai760
General Maxima Discussion
12
Jul 2, 2003 12:33 AM
Back to Subforum
5th Generation Maxima (2000-2003)
View Next Unread
5th Gen Thrbody gaskets & metal intake piece?




Advanced Search

All times are GMT -7. The time now is 07:47 AM.