Under my hood.
woah, when did you get that intake that has the filter on the top?
03-23-2008, 04:15 PM
#22
I have been working on mine on and off for the past couple of weeks and it is coming together I think. Waiting on my polished Injen CAI and I am still debating which STB to get. All of the above look really good especially yours Chern. Hope to have me a turbo in the near future.
The blue is darker than what it looks in the pictures and it is a anodized look on the finish and all silver pieces are metallic.
The blue is darker than what it looks in the pictures and it is a anodized look on the finish and all silver pieces are metallic.
Last edited by wildman04; 03-23-2008 at 04:19 PM.
03-23-2008, 08:42 PM
#29
I painted the lettering first let it dry and then taped over the lettering and trimmed tape to the edges of the letters. Logo, just tape it up and cut out the letters. Apply alot of pressure to the tape so you can see the edge where to trim and use a very sharp knife. Someone else might direct you to an easier way but this works. Good luck with your project.
i'll take some tomorrow ok taz and yes i'll make sure the tower brace is visable
03-24-2008, 05:34 PM
#35
Member
Thread Starter
Join Date: Aug 2006
Location: Dirty NJ
Posts: 71
03-24-2008, 06:12 PM
#36
Wink. I'll do the rest.
Join Date: Aug 2006
Location: Coral Springs, FL
Posts: 860
I painted the lettering first let it dry and then taped over the lettering and trimmed tape to the edges of the letters. Logo, just tape it up and cut out the letters. Apply alot of pressure to the tape so you can see the edge where to trim and use a very sharp knife. Someone else might direct you to an easier way but this works. Good luck with your project.
03-24-2008, 06:40 PM
#37
03-24-2008, 07:02 PM
#40
Wink. I'll do the rest.
Join Date: Aug 2006
Location: Coral Springs, FL
Posts: 860
I think I remember reading a post while ago that said you didn't have to sand.... I am interested in this too so I can paint mine ..... KCMaxx, Ap53?