GE members I have a 14 sv. It's going into limp mode whenever it rains hard. Does anyone know what would be causing this

 

We'll be sure to check our magic ball

 

Any flashing lights displayed right before going into limp mode? Are there any stored codes?

 

You're kidding right? Please give more info, how was it behaving before limp mode, any warning lights lit on the dash, codes stored? Etc, hard to give any advice just by it goes into limp mode when it rains hard.

 

Sorry....crystal ball is a bit foggy today.....

 

That's an easy one, there's a loose nut behind the wheel.

 

lol

 

Limp? Try rubbing it

 

Yall are hilarious ....but no warning or check engine light
although a few months ago I got a maf code I cleaned it and it went away

 

Also it only lasts for about 5 minutes then its fine

 

Pull your codes, there may be a pending list. If it is going into limp mode, it will throw codes. Have a scanner ready next time. I use the Torque app and the BAFIX OBD dongle.



Let us know.

 

I would start with that right there, MAF sensor may have a code pending even if there's no check engine light on at this time you may have a pending code. Start there.

 

I have to get that app and dongle, I've read good stuff about that.

 

You still don't have it? 😷
Good affordable dongle the BAFX. Don't listen to reviews saying it just read basic OBD data. The type of data depend on the app not on the dongle (at least this one can read all CAN bus data). The magic lies in the PIDs.

 

Yea I know I been sleeping on it, But I am going to get it much sooner than later..