Hello everybody, im new to the forum. Glad to be here. Im writing this as i cannnot for the life of me remove the driver side axle from the transmission. I already got it off the rotor all i need is the transmission. Ive tried keeping the axle straight and yanking on it while twisting it left n right but it wont budge. Also cant seem to get a pry bar in there due to the curve of the frame being in the way.I also dont want to damage the seals when removing it, but at this point i think im just gonna go ahead and replace the seals as well. For context the maxi has 202k miles on it, the axles have never been replaced. If anybody has any suggestions please by all means im open for anything at this point. Looking forward to being a part of the community.

 

It's not in English...but should give you enough.

 

it's all good, spanish is my first language. thank very much for the reply.

 

Excellent! Good luck!

 

Please let us know how you make out with this.

 

I was able to slide a long bar between the subframe to reach edge of axle where mesh into transmission, and bang out with hammer.

 

Thank you to everybody who took their time to reply to this thread. after 3 middle of the night trips to my local 24hr autozone (shoutout to autozone). I was finally able to use a pry bar to replace the axle. All is well now just gotta torque down the bolts and take her out for a spin. Once again thank you everybody!

 

Just got back from a test drive all is well. Decided to also change the ctv oil as well. Here's to our Maximas, cheers!