I'm helping my friend out with his 3.5 swap and I had these made.


All measurements were taken with calipers and they were made with a waterjet CNC machine.
Two good things about these are:
The dowel pin hole is slotted to allow for some inner to outer play when drilling the intake cams.
The overall OD is the maximum allowable diameter that will fit behind the inner vq30 timing sprockets. I did this for added strength around the dowel pin area.
I made a few more sets too if any of you guys are interested, pm me.
Please note these are spacers not adapters.

 

bump can vouch for 95naSTA and the spacers. I was there when all measurements were taking and then when they were test fitted.

 

So I would still have to drill to advance/retard the cam timing. Interesting.

 

How much for a set, we are preparing the 3.5 swap for one of my friend.
those spacers aren't the only solution out there for us. Was just curious about the price you sell those, we're on a budget and looking all the solutions possible... post the price please and shipping cost to Province of quebec, canada!!! thanks!!!

 

If anyone is interested just pm me. That seems to be the way people are selling things like this on here. FWIW, I think I'm selling them for cheaper than what they have been going for.