i recently had an amp and subs installed by a friend of mine who runs a buisness. anyway, after he installed them and i was on the way home, the air bag light beside the blinkers in the dash started blinking. wasnt sure to post this here or not, but anyone with an idea please help.

 

your friend runs a car audio business? How long has he been doing it for? If you trust him, call him up and tell him to rewire it the right way and get your money back from him.

 

Probabaly disconnected your airbag during the install and reconnected the battery before pluging the airbag back in. Computer got signal that something was wrong, that's why it is flashing. You will have to reset the airbag light. Dealership charges around $60.00 for this.

 

how can u wire it wrong? i don't have a business and not a pro but i built my second system already from scratch and wired everything myself and never had any problems.... if u r a pro u should know this like 123 and never have a problem if u do it for a living..... it might not be the wiring it could be the car.....

 

ok, breathe in breathe out...simple problem that was just an accident

prolly just that he disconnected the airbag sensor. won't cost you $60....

http://maxima.theowensfamily.com/
the site is currently down but keep on checking. there is a write up one how to reset your airbag light.

 

thanx i'll try to breath correctly ....

 

if he had an amp and subs installed, why in the frick would the installer disconnect the airbags? that is just retarded. i bet there's a deeper rooted problem going on here...

 

He may have removed front seats to lay the power cable and rca cables under the carpet. To do that he would have to disconnect the side impact airbag cable attached to the seats. That is if the airbag is in the seat like in my '98.