my friend has 3 jl 12 inch subs now the guy he bought them from had them hooked up to 6 ohms
so i hooked them up into 1 ohm
tested it out

worked fine....btu when i turned it up more it would cut off and the AMP would read E-3 which is high voltage i think

now im nto understand how can i fix this and is the 1 ohm load affecting the amp because it says it can handle it
-J

 

that amp is not 1ohm stable....

 

really?? so what i ahve to wire it to two ohms??

how do i do that ??

 

Not sure how you do that with 3 subs on a mono amp.....sorry