Newbie in Audio, need help with amp
#1
Newbie in Audio, need help with amp
Front 6.5 Eclipse components
Back 6.5 Eclipse SE8363
One 10' sub in trunk
My question is what kind of amp do I use to power this stuff? Do I need an amp to power the components? Any recommendations would be helpful.
Back 6.5 Eclipse SE8363
One 10' sub in trunk
My question is what kind of amp do I use to power this stuff? Do I need an amp to power the components? Any recommendations would be helpful.
#2
Well, it depends upon what type of deck you have, and how much power it puts out. You have a couple of routes here.
1. Get a 5 channel (memphis makes 2 of them) They're kind of pricey though.
2. Get a 4 channel and hook the components and sub up to it. And the rear speakers to the deck
3. 4 Channel, and bridge the sub, and hook the speakers up as normal
Components usually work the best when powered. Some even require a decent amount of power to run... like Memphis's M-Class 6.5" Multi sync components.
1. Get a 5 channel (memphis makes 2 of them) They're kind of pricey though.
2. Get a 4 channel and hook the components and sub up to it. And the rear speakers to the deck
3. 4 Channel, and bridge the sub, and hook the speakers up as normal
Components usually work the best when powered. Some even require a decent amount of power to run... like Memphis's M-Class 6.5" Multi sync components.
#3
Directed Viper 1100d5 ... it is cheap and will run all that equipment very well.
75 x 4 plus a class D subwoofer channel that will do 600 watts @ 1 ohm.
There's also a non-viper version that I believe is only different in the slope of the internal crossovers.
75 x 4 plus a class D subwoofer channel that will do 600 watts @ 1 ohm.
There's also a non-viper version that I believe is only different in the slope of the internal crossovers.
Thread
Thread Starter
Forum
Replies
Last Post
popdedop
7th Generation Maxima (2009-2015)
6
09-11-2015 11:17 AM