New HU + Rio Car and installation problems
#1
New HU + Rio Car and installation problems
Well I finally got time to install my rio car and new HU. Ran into some slight problems so the job is kinda incomplete. First I after about 30 minutes of trying, I got the vents off the top console. Next everything is going pretty smooth, until I try and remove the stock HU from the console. I got 6/8 screws out with np, but there were 2 that didn't want to come out. They're pretty much stripped. So I have the stock HU, just not plugged in, and my Pioneer 7400 in the compartment space below. I would have rather put my Rio car in, but it didn't fit. I know some of you guys put one in, how did you get it to fit nicely so you can slide it in and out? Also how should i go about removing the stock Hu from the middle console part since the screws are stripped.
Thread
Thread Starter
Forum
Replies
Last Post
Lakersallday24
6th Generation Maxima (2004-2008)
13
03-20-2024 11:22 AM
Lakersallday24
6th Generation Maxima (2004-2008)
10
06-16-2019 01:35 AM
SmokinMax02
5th Generation Maxima (2000-2003)
18
09-11-2015 12:25 AM
Team STILLEN
Autocrossing and Road Course Racing
0
08-10-2015 04:29 PM
kirkhilles
5th Generation Maxima (2000-2003)
2
08-08-2015 10:53 AM