I recently bought an aftermarket spoiler and had it installed, however when I hooked up the wiring to the factory wiring( i think black wiring for ground and green/yellow for power) i blew the 15a fuse for the stop light circuit. I even attempted to attach it to the third brake light connector and got the same results I was wondering if any of you guys encountered this problem. I am beginning to think that the ballast(brake light on the spoiler) may have too much resistance for the brake circuit and I don't want to cause any short out something that I may regret. Any suggestions would be appreciated. I think my next call is to where I bought the spoiler and see if there they have any ideas.

 

bump?