Michael Ricci=Unscruplous
#1
Supporting Maxima.org Member
Thread Starter
iTrader: (2)
Join Date: Sep 2002
Location: St. Simons, GA
Posts: 364
Michael Ricci=Unscruplous
This is to state that Michael Ricci sold me an RVM UD pulley knowing full good and well it was a second OIL PUMP TO THE GROUND!!!!!
I have had this thing in a box and took it out today....no sleeve, and worn to bits where the oil seal goes, I know, I know, should have checked the threads but this happened a good while back, but he know full good and well what he was doing, I never even told him to send it, it just showed up at my door and I knew if I didn't pau him I would end up with my name here do I did in good faith....now I have a paperweight.....
Lesson Learned!!!!
I have had this thing in a box and took it out today....no sleeve, and worn to bits where the oil seal goes, I know, I know, should have checked the threads but this happened a good while back, but he know full good and well what he was doing, I never even told him to send it, it just showed up at my door and I knew if I didn't pau him I would end up with my name here do I did in good faith....now I have a paperweight.....
Lesson Learned!!!!
#3
Supporting Maxima.org Member
Thread Starter
iTrader: (2)
Join Date: Sep 2002
Location: St. Simons, GA
Posts: 364
Waited WAAAAAY to long to do that, it must have been in the box a year in my office before I even opened it........and that is MY FAULT! Should have checked sooner, but I figured WTH I'll use it one day, (this was before I found out about the bad history on RVM) well the day came and guess what.........oh well live and learn!
RVM never made any of their BS right did they? Cause I still have a paperweight.......
I might could get a machinest friend of mine to sleeve it for me, and then make a STEEL timing ring, I did check and timing ring is NOT ferrous metal, don't know if it's stainless or aluminum but it sure aint magnetic!
L8r
RVM never made any of their BS right did they? Cause I still have a paperweight.......
I might could get a machinest friend of mine to sleeve it for me, and then make a STEEL timing ring, I did check and timing ring is NOT ferrous metal, don't know if it's stainless or aluminum but it sure aint magnetic!
L8r
Thread
Thread Starter
Forum
Replies
Last Post
mb1
4th Generation Maxima (1995-1999)
23
10-04-2002 01:49 PM
MichaelAE
General Maxima Discussion
9
07-25-2002 03:05 PM