I'm trying to install my PR CAI and I need to find a 3.25 hole saw. Iv'e been to Pep Boys and Home Depot so far, they were the only places still open. The only thing Ive been able to find so far is a 3" and a 3.5". It says you can use the 3.5, but I want to do a clean install and not have all that gap. Any ideas/info? Thanks in advance

 

check out www.maximadriver.com check out How2 section.. it might say where to get it but it does say how to install it.. im still waiting for my CAI.. They said its going to take 4 weeks cuz they are outta stock.

 

I already got the install tips, thanx anyway. 4 weeks?! I just ordered mine on monday, and it came today, seems kinda off, though I think a big group order just went through, so it's a possiblity. good luck on yours, if you need any pointers, I'm sure I'll know them by then. I'm so excited, now if I could only find that damn hole saw....

 

Got mine at Sears Hardware. Cost around $15, I think...it's been a while. Any hardware store (Lowes, Home Depot, etc) should have it.

 

where are you at??? i bought mine from a hardware store...
just buy the 3.25 hole saw and drill tip and go to town..

 

hey mtrai,
Are you going to the meet on Sunday? Lemme know how things go with the install.

 

I've been involved with 3 CAI installs, in in every case we used a 3" hole saw. The only drawback is there is not enough room to use the rubber hole liner provided. I just put a little metal primer on the bare metal.

 

I used touch up paint and a 3 inch hole saw also

 

hmmm...i used a 3.5" lol!...probably cause the VG piping goes in at more of an angle