Throtle Cable Sensor cause check engine light???
#4
The TPS is the black box on the throttle body, on the right side facing the firewall. It's just 2 little screws holding it in. Keep in mind that when you remove it, you have install it with proper specs. The resistance should be around 500 ohms reading pin one on the connector.
#7
Originally Posted by Ammi
So removal of TPS is not required when you replace your entire block?
wow. just... wow.
removal of the wire bundle to the TPS via a connector is required when replacing an engine, yes.
removal of the TPS.... figure it out.
Thread
Thread Starter
Forum
Replies
Last Post
Justinmc760
4th Generation Maxima (1995-1999)
11
08-23-2015 03:10 AM
maxinout93
5th Generation Maxima (2000-2003)
3
08-20-2015 02:17 AM
bassmann
4th Generation Maxima (1995-1999)
1
08-03-2015 07:53 PM