Installed AE Foglights A33 01 I30
#1
Installed...Cefiro AE Foglights A33 I30
I just like the way they look over the OEM fogs. Got these Thursday, painted BW9 and cleared. I think they look way better than all the plastic on the OEM ones.
Last edited by Joeker82; 09-10-2011 at 08:04 PM.
#3
It's just the way it is. Im gonna get some gasket tape to wrap around the inside of the light to seal off the gap.
Plus, your just noticing it more becuase the pic was taken in a up angle. You dont really notice it as much, unless your bending down looking at it. The tape should clear up the gap.
Plus, your just noticing it more becuase the pic was taken in a up angle. You dont really notice it as much, unless your bending down looking at it. The tape should clear up the gap.
Last edited by Joeker82; 09-10-2011 at 08:03 PM.
#8
In my thread, you said that you didnt have an issue putting the cap on....how is that possible with HIDs? On mine, the two wires coming from the ballast to the bulb is what causes the problem. You have to connect the wires to the prongs on the inside of the cap, then plus the harness in on the outside. This leaves no way for the cap to screw on.....unless you did something to modify the housing or cap. Details.
Also, a note on the gap....it is normal, and I wouldnt be surprised if you ran into issues with it fitting on the outter corners. It is the way they are molded and dried...the pieces tend to shrink once out of the mold. Just the name of the game.
Also, a note on the gap....it is normal, and I wouldnt be surprised if you ran into issues with it fitting on the outter corners. It is the way they are molded and dried...the pieces tend to shrink once out of the mold. Just the name of the game.
Last edited by tsi1991awd; 09-11-2011 at 03:56 AM.
#12
I think its useful feature. Its always good to see the corners, especially if you have tints. I delivered pizzas for over 4 years so I have plenty of experience, but still I think corner lights increase safety.
#13
Thread
Thread Starter
Forum
Replies
Last Post