Sunroof Wind Deflector
how in the hell do these things go on? The directions I got we're complete trash. The clips dont seem to be long enough. The visor didnt have a year on it it just said "MAXIMA"... perhaps its a 5th gen, are they different? If you have detailed instructions on how to put these on please reply
thanks
thanks
Guest
Posts: n/a
Did you buy one from nissan, or did you get one from pepboys or somewhere like that? I got mine from pepboys and all you hade to do was buy one that was long enough, they don't make one for a maxima or any other car from pepboys you just have to find one that fits. The pepboys one has two sided tape on it and all you have to do is pill the tape off and then stick it where you want it. I don't know anything about the nissan one. I would just stick some tape on the end and put it up there if you have a nissan one hope this helps.
yea i got it
The clips sucked, I got it on though. It's the nissan one and I used the maxima clips. It was a pain in the *** to get the screw through the clip (very short), it took me and my friend like 10-15 minutes to get it on. It looks pretty nice IMO. Also blocks alot of air noise when sunroof is opened.
Deflector..
It's a ***** to clean. I used to have one on my car, i took it off. It will trap dirt underneath that rubber part eventually, and it will scrape your paint. Youll either have to scrub like a **** to clean it up (cleaner wax/fine cut polish) .. or sooner or later, youll have lil chip spots. (i have some)
Im referring to the nissan one, btw.
Just fyi :>
Im referring to the nissan one, btw.
Just fyi :>
I had one on my 96 seand when iI got the car I took it off to wash.It was very dirty in there and the next year I took it off again to wash and left it off.The car is white and I have a yellow line from the rubber seal was at.I could not tell a difference at all with it on or off the car.
Thread
Thread Starter
Forum
Replies
Last Post
Forge277
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
12
Jun 13, 2016 09:26 PM



