Hey guys...
Does any1 know if i can turn the rotor or have it honed?

If yes, are there any drawbacks?

 

Honestly, the most I would do with those things is have them resurfaced. They have such a short life to begin with it ain't even worth it to keep repairing them. Just my opinion.

 

Would this screw up the drilled holes and make it eat the pad faster?

 

I don't know about speeding up the process...but like I said, these things have low lifespans so it won't extend it that long in my opinion.

 

Most companies will not turn rotors b/c of the time needed. They ahve to do it alot slower than the normal rotors so they don't "bite" the bit on the lathe. I asked a company one time and he was like for 75 buck i will. UMMM No.